DEVICE TORQUE TEST SYSTEMS

PROGRAMMING FEATURES

Programming Features

Uni-directional Test: This test will rotate the DUT (Device Under Test) in the direction selected on the keypad and the peak torque will be measured and displayed. The test results can be saved in memory or outputted through the RS 232 port. The test speed and the distance or time to test is programmable.

Bi-directional Test: This test will rotate the DUT in both directions and the peak torque will be measured and displayed. Both measured values will be displayed and can be stored in memory and outputted. As seen in the single direction test, the speed and the distance or time to test is programmable.

Set Torque Test: This test will rotate the DUT in the direction selected until the set torque is achieved or the torque drops off suddenly. If the desired torque is not reached the drop off value will be captured and displayed. Once again the results can be stored or outputted. This test can be performed in either or both directions and at a programmable speed.

Multi-Tests: The tests described above can be performed a programmable number of times, with naps between tests, to life test a device.

Testing Made Easy 

Just select a test to run from the select test profile screen. The selected profile will then be loaded from memory and the software will advance to the run screen.

Run Screen 

Just press Start and the test will be performed and the results displayed. Pass / Fail limits can be programmed to automate the decision process.

Creating Test Profiles: 

Easy to use programming menus enable the user to customize a test to the requirements of almost any application.